• Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語

Export SD/USB flash drive

This article is also available in following languages: 

PrusaSlicer automatically detects if you insert an SD card, USB flash drive, or other removable media.

When detected, a new Export to SD/USB drive button will appear next to the Export G-code button (bottom right corner). Clicking it will open the file save dialog with the path initialized to the SD card or USB flash drive.

If multiple SD cards or USB flash drives are detected, the file dialog is opened at the last visited removable media.

Once a G-code is exported to a removable media, an Eject button is shown next to the Export G-code button, which will safely disconnect your device.

Was this article helpful?


Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us