Get support | Prusa Knowledge Base

The search bar on top of this site searches the entire PrusaSlicer documentation as well as assembly guides and related printer hardware troubleshooting guides. If neither has the answer to your problem, you can try several things:

PrusaSlicer forum on prusaprinters.org

The PrusaSlicer forum is an active community of PrusaSlicer users. You can post your problem there and discuss it with numerous expert users in the community.

Facebook groups

If you use Facebook, there are several active groups that are quick to help you with your problem:

Report an issue - Github

Even though the PrusaSlicer team has 7 full-time developers and several active community contributors, going through reported issues and feature requests take a considerable amount of time. Before you report a new issue, please make sure you've exhausted other options.

There is a good chance that the issue is already reported, you can check the list of reported issues here.

Finally, you can create a new issue here.

Was this article helpful?

This action is available only to registered users. Please log-in.

6 comments

Tim

•

Prusa, you have an issue with 6.4.0 SW release. I have a MK4S with a mmu3.
Initial beginning, I load the machine with filament to the hot end. Then I set the machine up with the print I want. When the machine starts to print it starts its' run by expelling the strip at the head of the sheet. Then the extruder parks to the right side and stays there. The display reads "Reloading Filament" 99% parking, it never recovers.
I have to reset the machine, unload the filament and then choose the print again. Then it works. The difference is that I'm not preloading the hot end.
Previous SW version did not have this issue.

Jlh59766***

•

Mk4s printer keeps crashing.
Crash detected.
I have turned it on and off and sometimes it worked.
Did a factory reset. It then worked for one print and is now crashing again. Very frustrating

Abel.Pena517

•

Is there a way to cancel mid print an item on the XL ? Example. Printing box with a lid at the same time and i want to cancel the lid but continue printing the box.

TFI Services

•

I have a perfect model of a radial engine that prints well. I want to scale it up 190% uniformly, which I can do successfully by using the uniform scale command . However I would like to reduce the density of the model. In other words the scaled up version is 90% heavier than the original and I want to reduce the weight. Can I do this and if so how?

Mikolas Zuza

•

You adjust the infill density, the number of perimeters and the number of top and bottom layers and see how the estimated weight changes in the slice preview. The infill density is likely the main thing you can significantly lower to reduce weight, without sacrificing print quality.

Doug

•

So sorry! It was my CAD file. I had a few features projecting out .007" which caused the problem. All OK and printig perfect.

William H. - Official Prusa

•

Glad to hear you figured it out. You might find this article helpful:)