The Live Z Adjust is a tool that is used for easy corrections of the 1st three layers of your prints. In this article, we will look at the most common problem associated with it, which is when the value is not storing.
Most likely this problem is occurring due to the fact that you have skipped a step in the calibration flow. The printer would then display:
"Distance between the tip of the nozzle and the bed surface has not been set yet. Please follow the manual, chapter First steps, section First layer calibration."
Unless you finish the calibration process. Your printer will not be able to store its Live Z data. Therefore please make sure that calibration flow was followed precisely and finished entirely.
Steps to follow once your printer has been assembled: