• Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語

Slicing mode / 3DLabPrint airplanes

Last updated 2 years ago
This article is also available in following languages: 
Some options will not appear when PrusaSlicer is in Simple mode.

Slicing mode


The default behavior uses the Positive fill rule.

Even-odd - 3DLabPrint airplane models

PrusaSlicer supports the slicing of 3DLabPrint airplane models. These 3DLabPrint models were designed to be sliced with Simplify3D with a single perimeter and no infill to produce a lightweight wing reinforced by single perimeter ribs. From the solid geometry point of view, these models contain overlapping bodies and are not valid solid models. But because the models were designed specifically for Simplify3D and the way it evaluates such objects, the exported G-code was correct. To allow slicing the 3DLabPrint models, PrusaSlicer implements a new “Slicing Mode” option, allowing one to switch between the “Positive” (default) and “Even / Odd” fill rule.

Use the “Even / Odd” option to slice 3DLabPrint airplanes correctly. Check out the 3DLabPrint PrusaSlicer tutorial for more information about how to slice their models.

Close holes 

Makes PrusaSlicer fill in all internal structures.

Was this article helpful?


Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us