1. Tools necessary for this chapter

Prusa CORE One+ kit assembly

• 1. Introduction
• 2. Base assembly
• 3. Back assembly
• 4. Heatbed assembly
• 5. CoreXY assembly
• 6. Nextruder assembly
• 7. Bodywork & Electronics
• 8. Trim, Door & xLCD
  1. Tools necessary for this chapter
  2. Top cover: parts preparation
  3. Removing the foil
  4. Test-fitting the top cover
  5. Assembling the top cover I.
  6. Assembling the top cover II.
  7. Testing the ventilation
  8. Installing the top cover
  9. Side covers: parts preparation
  10. Removing the foil
  11. Covering the left side
  12. Covering the right side
  13. xLCD: parts preparation
  14. Assembling the xLCD I.
  15. Assembling the xLCD II.
  16. Installing the FE Faston connector
  17. Installing the LCD knob
  18. xLCD bezel: parts preparation
  19. Mounting the xLCD I.
  20. Mounting the xLCD II.
  21. Installing the xLCD assembly
  22. Securing the xLCD assembly
  23. Door seal: parts preparation
  24. Attaching the top seal
  25. Attaching the side seals
  26. Magnet holders: parts preparation
  27. Assembling the magnet holders
  28. Installing the magnet holders
  29. Hinges: parts preparation
  30. Installing the door-hinge-in parts
  31. Installing the door-hinge-out I.
  32. Installing the door-hinge-out II.
  33. Door panel: parts preparation
  34. Door panel: removing the protective film
  35. Installing the door panel
  36. Assembling the door handle
  37. Securing the door handle
  38. Attaching the sticker: Parts preparation
  39. Attaching the sticker
  40. Haribo time
  41. Done
• 9. Calibration & First run
• Manual changelog