EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語
Login

Manual changelog

Manual changelog
Relevant for:
Last updated 4 years ago
Manual changelog
 Difficulty
Moderate
 Steps
7
 Available languages
CSPLESDEITFRJA
Versions history
Versions history
Versions of the MK3S manual:
02/2019 - Initial version 3.10
03/2019 - Updated to version 3.11
07/2019 - Updated to version 3.12
09/2019 - Updated to version 3.13
06/2020 - Updated to version 3.14
07/2020 - Updated to version 3.15
Changes to the manual (1)
Changes to the manual (1)
03/2019 - Chapter 2 (Y-axis)
PSU holders assembly now depends on the type of the PSU, which is in your kit.
03/2019 - Chapter 7 (HB & PSU)
Chapter 7 is now in two versions depending on the PSU type, which is in your kit.
New PSU is fully black, old PSU has silver casing.
Manual version 3.11
Changes to the manual (2)
Changes to the manual (2)
05/2019 - Chapter 7 (HB & PSU)
Heatbed-cable-cover design improved to prevent collision with the extruder cables, which sometimes occurred. All screws are now facing down.
New design with circular holes in the top part. The smaller part has hexagonal holes.
Old design with hexagonal holes in the top part. The smaller part has circular holes.
Manual version 3.11
Changes to the manual (3)
Changes to the manual (3)
07/2019 - Chapter 1 (Introduction)
The printer's package contains a lubricant, which is intended for maintenance. No need to use it now the bearings are lubricated. There is a dedicated online manual on how to clean the printer and apply the lubricant. See Maintenance tips
Several tweaks and new photos across the entire manual.
Manual version 3.12
Changes to the manual (4)
Changes to the manual (4)
Changes to the manual (4)
09/2019 - Chapter 1 (Introduction)
Added warning about the ESD protection. Keep the electronics in the bag until needed for the assembly.
09/2019 - Chapter 5 (Extruder)
There is a new hardware revision of the IR-sensor with some optimisations. Filament detection is the same.
Manual version 3.13
Changes to the manual (4)
Changes to the manual (4)
Changes to the manual (4)
06/2020 - Chapter 2 (Y-axis assembly)
New photos across the chapter show the position of PSU holders M3nE for Black PSU.
06/2020 - Chapter 5 (E-axis assembly)
FS-cover assembly step is moved a few steps earlier to prevent the IR-sensor from being damaged during assembly.
06/2020 - Chapter 8 (Electronics assembly)
New photos in this chapter include cable guiding from the Black PSU.
Manual version 3.14
Changes to the manual (5)
Changes to the manual (5)
Changes to the manual (5)
Changes to the manual (5)
07/2020 - Chapter 2 (Y-axis assembly)
The correct orientation of the bearings on the Y-carriage has been adjusted.
The correct orientation, the tracks (rows of the balls) are on the sides.
The incorrect orientation, the track is in the middle of the hole.
The printed version of this manual (v3.14 and older) suggests a different approach, please follow the online version instead.
Added instructions, how to glue the silver label on the frame.
Manual version 3.15
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us