On the Original Prusa XL, communication with the peripheral boards (e.g. Dwarf board) is achieved using the MODBUS protocol. In MODBUS, there are two types of devices: the master and the slave, also known, respectively, as client and server. On Original Prusa XL firmware, the master is the XLBuddy, and each slave is called puppy.
In this context, the word discovery refers to the process of identifying each puppy, and determining their available functions and communication parameters. In case none of the puppies respond to the XLBuddy requests in this phase, the printer will show the message: "Puppy discovery error. No puppy found".
Error name: Puppy discover err
Error code: #17513
The error most likely indicates an issue with a loose, broken, or incorrect connection.
Inspect the wiring on the Sandwich board for a cable positioned into an incorrect port, a loose connection, or a visibly broken cable.
Download the firmware and if necessary the bootloader, and transfer it to your USB drive. Make sure to unmount the drive from your operating system before physically removing it.
Insert the USB drive back into the printer and reboot the printer using the reset button directly next to the knob to initiate the flashing procedure. In case the procedure does not start, reboot the printer again by pressing the same reset button, and while the printer is booting up, press once the rotating knob.
Se hai una domanda su qualcosa che non è trattato qui, dai un'occhiata alle nostre risorse aggiuntive.
E se questo non dovesse funzionare, è possibile inviare una richiesta a [email protected] o tramite il pulsante qui sotto.