English
Čeština
Español
Italiano
Deutsch
Polski
Français

Loud noises from printer (SL1/SL1S)

Relevant for:

SL1 SL1S

Last updated a year ago

This article is also available in following languages:

When your printer emits loud noises, sounding like hammering onto sheet-metal. This can be caused by a firmware issue, or if resin has leaked into your printer through the tilt platform.

A clogged (flooded) sensor of the tilt-mechanism can cause it to not move as intended.

First, check that your firmware is up to date. If you have the latest available version installed and the problem persists, remove the black cover and check whether the sensor under the tilt motor is clean. If there is resin on the sensor then remove it with a piece of paper towel and make sure the sensor is perfectly clean – otherwise, the reading will be affected.

Was this article helpful?

Easy to understand

Solved my problem

Other reason

Comments

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.