• English
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Relevant for:
Last updated 2 months ago
This article is also available in following languages: 

The calibration shouldn't run on multiple printers side by side simultaneously. The neighboring printer performing similar motion may affect the measurement.


How it works

The printer will move the print head (in the case of the Multi-Tool it will select the first print head) to the middle of the bed and start to move the tool diagonally for the X and Y axes at different speeds - while collecting data from the accelerometer located on the Dwarf. The goal is to measure the characteristics of the motors and store these settings


For more information please check the Release Notes

Was this article helpful?


Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us