JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Manual changelog MINI+ kit

Manual changelog MINI+ kit

Manual changelog MINI+ kit
Relevant for:
Last updated 5 months ago
Manual changelog MINI+ kit
 Difficulty
Very easy
 Steps
5
 Available languages
ENCSPLDEESITFR
Version history
Version history
Versions of the MINI+ kit assembly manual:
01/2021 - Initial version 1.05
02/2021 - Updated to version 1.06
03/2021 - Updated to version 1.07
11/2021 - Updated to version 1.08
05/2023 - Updated to version 1.09
マニュアルの変更点 (1)
マニュアルの変更点 (1)
マニュアルの変更点 (1)
マニュアルの変更点 (1)
02/2021 - YZ-axis assembly
Improved inspection holes to check the insertion of the smooth rods in the MINI-Z-bottom.
02/2021 - X-axis & Extruder assembly
Added inspection holes to check the insertion of the smooth rods in the MINI-X-end.
02/2021 - X-axis & Extruder assembly
The dimension of the gap between the motor and the X-axis pulley has been changed from 2 mm to 0.7 - 1 mm.
Manual version 1.06
マニュアルの変更点 (3)
マニュアルの変更点 (3)
11/2021 - LCD assembly & Electronics
New kit units are shipped with a silver label already affixed to the Z-axis extrusion.
Manual version 1.08
マニュアルの変更点 (4)
マニュアルの変更点 (4)
05/2023 - Spool holder assembly
Added instructions for assembling the new version of the Spool holder (injection molded).
Manual version 1.09
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us