What happened?
MMU3 operates with 5 “tools” (materials - filament positions), labeled 1 - 5 on the unit. The desired filament position is selected by G-codes T[number]:
T0: Filament 1
T1: Filament 2
T2: Filament 3
T3: Filament 4
T4: Filament 5
Tx: Lets the user select a filament position from the LCD menu
T?: Legacy G-code for Tx
If you, for example, issue a T5 command to the printer, this error will be shown, because the tool range available for MMU3 is T0-T4 only.
How to fix it?
If you use a 3rd party software to control the MMU printer, make sure the number of extruders is set to 5; counting from T0 to T4.
In case you are using a 3rd party hardware solution allowing for more than 5 materials to be used, please use the corresponding 3rd party firmware for the device too.
Byl tento článek užitečný?
Tato akce je dostupná pouze registrovaným uživatelům. Prosím přihlaste se.
Pro přidání kometáře se prosím přihlaste
Zatím žádné komentáře