JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

2. Unpacking the printer

Menu

2. Unpacking the printer

2. Unpacking the printer
Relevant for:
CORE One
Last updated 5 days ago
2. Unpacking the printer
 Difficulty
Easy
 Steps
6
 Available languages
ENCSPLDEESITFR

Step 1 Preparing the package

Preparing the package
Preparing the package
Preparing the package
Preparing the package
CAUTION: The package is heavy—handle it with care!
The package fixations and foam inserts may vary.
⬢Open the package. On the top layer, you will find:
⬢Print sheet
⬢USB drive
⬢Power cord
⬢Remove these items from the package and place them in a safe spot for later use.
⬢Remove the cardboard protection layer.
⬢Take out the Prusament cardboard box and set it aside.

Step 2 Removing the box

Removing the box
Removing the box
Removing the box
Removing the box
⬢Notice the two cutouts (handles) on both sides of the cardboard layer. Bend them upward.
CAUTION: The printer is heavy—handle it with care!
⬢Grasp both handles and CAREFULLY lift the printer out of the box.
Tip: Ask someone to hold the bottom cardboard box in place to make it easier to lift the printer out.
⬢Place the printer on a stable and clean surface.

Step 3 Removing the protective foams

Removing the protective foams
Removing the protective foams
Removing the protective foams
⬢Remove the top protective foam from the printer.
CAUTION: The package is heavy—handle it with care!
⬢Grasp both handles and CAREFULLY lift the printer from the bottom protective foam.
Tip: Ask someone to hold the bottom protective foam in place to make it easier to lift the printer out.
⬢Remove the bottom foam.

Step 4 Removing the cardboard layer

Removing the cardboard layer
Removing the cardboard layer
Removing the cardboard layer
Removing the cardboard layer
⬢Carefully turn the printer to its "natural standing position" with the orange door handle on the right side.
⬢Detach the two ends of the cardboard protective layer from each other by pulling the upper layer out.
⬢Fold down the cardboard protective layer away from the printer.
⬢Now, you can completely remove the cardboard layer from the printer.

Step 5 Removing the inside protections

Removing the inside protections
Removing the inside protections
Removing the inside protections
⬢Open the door.
⬢Locate two cardboard fixations on the X-axis. There is a notch on the underside that releases the fixation.
⬢Pull the notch, release, and remove the fixation.
⬢Using the same method, remove the second fixation.

Step 6 Preparing the Tool pack

Preparing the Tool pack
Preparing the Tool pack
Preparing the Tool pack
⬢The tool pack is located on the right side of the printer.
⬢Remove the cardboard tool pack from the printer.
⬢Open the tool pack completely. Inside, you will find:
⬢xLCD assembly package
⬢Tools package - contents are described in the first chapter
⬢Keep the content aside for later use. Now let's go to the next chapter: 3. Mounting the xLCD
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us