• Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語

Simple, Advanced, Expert modes

This article is also available in following languages: 

The user interface changes in appearance depending on the mode you’re in. You can switch to a different mode using the buttons in the right panel or by going to Configuration - Mode - Simple/Advanced/Expert.

The reasoning behind the Simple mode is to lower the learning curve for beginners and declutter the user interface for casual users. Complex features like modifier meshes are hidden, and only a basic subset of parameters is shown to the user.

In the Advanced mode, more parameters are shown, and in the Expert mode, all the power features of PrusaSlicer are accessible. To make the learning of parameters easier, we color-coded them

  • Green – safe to be tinkered with by a beginner
  • Yellow – advanced user may want to modify these parameters
  • Red – expert settings most of which should only be touched if you’re making a profile for a new printer

Was this article helpful?


Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us