1. Tools necessary for this chapter

Ensamblaje del Kit de Prusa CORE One+

• 1. Introducción
• 2. Montaje de la base
• 3. Montaje trasera
• 4. Montaje de la base calefactable
  1. Tools necessary for this chapter
  2. Base calefactable: preparación de las piezas
  3. Heatbed cable assembly (part 1)
  4. Heatbed cable assembly (part 2)
  5. Bed-cable-cover-bottom: preparación de las piezas
  6. Attaching the cable cover
  7. Heatbed carriage: parts preparation
  8. Preparing the heatbed carriage
  9. Installing the expansion joints
  10. RGB LED strip: parts preparation
  11. Installing the LED strip
  12. Attaching the LED strip diffuser
  13. Covering the RGB LED strip
  14. Guiding the RGB LED strip cable
  15. Bed mounts: parts preparation
  16. Assembling the bed mounts
  17. Securing the bed mounts
  18. Bed mounts: inserting the nuts
  19. Montaje de la CORE-One-bed-spacer-rear
  20. Instalando la bed-mount-right
  21. Instalando el bed-mount-left
  22. Mounting the heatbed: parts preparation
  23. Montando la base calefactable
  24. Apretando la base calefactable
  25. Covering the cables: parts preparation
  26. Guiding the heatbed cables
  27. Covering the heatbed cables
  28. Mounting the heatbed: parts preparation
  29. Attaching the heatbed assembly
  30. Mounting the heatbed assembly: rear motor
  31. Mounting the heatbed assembly: front motor left
  32. Mounting the heatbed assembly: front motor right
  33. Attaching the heatbed cables I.
  34. Attaching the heatbed cables II.
  35. Securing the heatbed cables: parts preparation
  36. Securing the textile sleeve
  37. Guiding the heatbed assembly cables
  38. Connecting the heatbed power cables
  39. Momento Haribo
  40. Listo
• 4. Montaje CoreXY
• 6. Montaje Nextruder
• 7. Bodywork & Electronics
• 8. Trim, Door & xLCD
• 9. Calibration & First run
• Lista de cambios del manual