6. LCD assembly

6. LCD assembly
Relevante para :
Ultima actualización 4 years ago
6. LCD assembly
 Dificultad
Moderada
 Pasos
12
 Idiomas disponibles
EN

Paso 3 Preparing the LCD support for assembly

Preparing the LCD support for assembly
Preparing the LCD support for assembly
Preparing the LCD support for assembly
Prepare the LCD controller and LCD-support printed parts as shown in the picture.
Ensure the correct orientation of parts and the LCD controller.
Slide the LCD-support parts on the LCD-controller.
The exact position will be adjusted in the next step, no need to worry at this moment.
You can now remove the protective foil from the LCD panel.
Cables are plugged to the LCD from the factory, but you can disconnect them.

Paso 4 Adjusting the LCD-support

Adjusting the LCD-support
Adjusting the LCD-support
Adjust the LCD-support parts as shown in the picture.
LCD-support parts must face directly into the cutouts in the LCD-cover.

Paso 5 Assembling the LCD-cover

Assembling the LCD-cover
Assembling the LCD-cover
Assembling the LCD-cover
Press the LCD controller with the LCD-support into the LCD-cover as shown in the picture.
Press it as deep as possible.
The LCD controller must click under support in the center of the LCD-cover.

Paso 8 Plug in the cables

Plug in the cables
Plug in the cables
Plug in the cables
Plug in the cables as shown in the picture.
Cable with 1 stripe has to be plugged in the connector labeled with EXP1.
Cable with 2 stripes has to be plugged in the connector labeled with EXP2.

Paso 9 Secure the LCD display onto the printer

Secure the LCD display onto the printer
Secure the LCD display onto the printer
Secure the LCD display onto the printer
Press the LCD assembly onto the front side of the Y-axis.
Best way is to press the LCD assembly on the top threaded rod first and then on the bottom.
Guide the LCD cables in between threaded rods as in the picture.

Paso 11 Guiding the LCD cables

Guiding the LCD cables
Guiding the LCD cables
Guiding the LCD cables
Guide the LCD cables using LCD-clips as seen in the picture.
Reverse direction of each of the clip, to prevent side movement of the cables.
¿Fue útil esta guía?

Comentarios

¿Todavía tienes preguntas?

¿Todavía tienes preguntas?

Si tienes alguna pregunta sobre algo que no se ha tratado aquí, comprueba nuestros recursos adicionales.
Y si eso no lo soluciona, puedes enviar una petición a [email protected] o mediante el botón que hay más abajo.

Contacta con nosotros