EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語
Login

Multiplexer

Multiplexer
Relevant for:
Last updated 5 years ago
Multiplexer
 Difficulty
Moderate
 Steps
3
 Available languages
CSPLESDEITFRJA
Remove Festo fittings
Remove Festo fittings
Remove Festo fittings from multiplexer.
Use the 8mm side of the wrench, which is part of the upgrade kit.
Check smooth entry of filament
Check smooth entry of filament
Using piece of filament make sure filament can pass into the PTFE tube without any resistance.
You should be able to freely insert at least 60 mm of filament.
Check all 4 entries.
PTFE tube entry
PTFE tube entry
Check entry of PTFE tube, tube must be without any damage and entry side must have tapered entry.
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us