• Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français

Object missing details

Relevant for:
Last updated 3 years ago
This article is also available in following languages: 

The Original Prusa SL1 3D printer can produce objects with an incredible amount of detail – tiny wrinkles on cloth of a figure, texture of skin, thin railings on buildings, etc. However, in case the printed object is missing small details (not entire parts of the model), it can be due to incorrect exposure times.

Make sure you are using the correct preset for your color/resin in PrusaSlicer!

Insufficient exposure

Too short exposure times will result in details being “melted” together. Increase the exposure times to recommended values to fix this issue.

Overexposed layers

Long exposure times will result in a “staircase” effect – the layers won’t blend into each other perfectly and some details may be lost due to this effect. Use the recommended exposure time values to fix this issue.

Was this article helpful?


Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us