1. Getting the necessary tools

Sestavení stavebnice Original Prusa i3 MK2

• 1. Introduction
• 2. Y-axis assembly
• 3. X-axis assembly [Překládá se]
  1. Getting the necessary tools
  2. 3D printed parts
  3. Preparing the rods
  4. Preparing printed parts
  5. Preparing tension screws
  6. Assemble the X-axis base
  7. Preparing the X-end idler
  8. Prepare the X-carriage
  9. Placing the X-carriage
  10. Tighten the X-carriage
  11. Cleaning up
  12. Assemble the X-motor
  13. Assemble the X-motor pulley
  14. Assembling the X-endstop
  15. X-endstop alignment
  16. X-Endstop check
  17. Cable management
  18. Cable wrapping
  19. All done!
• 4. Z-axis assembly
• 5. Extruder Assembly
• 6. LCD assembly
• 7. PSU & Heatbed assembly
• 8. Electronics assembly
• 9. Preflight check