English
1. Tools necessary for this chapter
Step 1 of 28 (Chapter 3 of 12)
Contents
Comments
⬢For this chapter, please prepare:
⬢Needle-nose pliers for cutting zip ties
⬢Philips (PH2) screwdriver
⬢2.0 mm Allen key for heatbed screws
⬢2.5mm Allen key for all M3 screws
Contents
Original Prusa i3 MK3/MK3S/MK3S+ to MK4 upgrade (1.01)
- 1. Introduction
- 1a. Parts check
- 1b. Printer disassembly
- Tools necessary for this chapter
- Opening the electronics box
- Disconnecting cables
- Removing the Einsy-base
- Removing the Einsy-door
- Removing the heatbed
- Dismantling cable management
- Removing the LCD assembly
- Dismantling the Y-axis: removing the belt
- Removing the Y-axis assembly
- Removing the Z-axis-tops
- Removing the cable-holder
- Removing the X-axis assembly
- Removing the Z-axis motors
- Removing the Z-axis-bottoms
- Removing the Y-motor
- Disconnecting the power cables
- Disassembling the Y-carriage: belt
- Dissasembling the Y-carriage: rod holders
- Disassembling the Y-carriage: bearings
- Disassembling the X-axis: Removing the pulley
- Removing the X-axis motor
- Removing the X-axis smooth rods
- Removing the X-axis bearings
- For new users of black PSU
- Parts summary
- Don't throw away
- Can I take a gummy bear yet?
- 1c. Parts preparation
- 2. Frame assembly
- 3. X-axis & X-carriage assembly
- 4. Z-axis assembly
- 5. Nextruder assembly
- 6. xLCD assembly
- 7. Y-carriage & Heatbed assembly
- 8. Preflight check
- Manual changelog
Comments
Log in to post a comment
griffdb
•
What I found helpful was having a turntable that I could set the printer on for disassembly. That way I could position the printer with respect to my articulated desklamp in order to facilitate access to the work.
Reply