English
1. Tools necessary for this chapter
Step 1 of 52 (Chapter 3 of 10)
Contents
Comments
⬢For this chapter, please prepare:
⬢Philips (PH2) screwdriver
⬢Needle-nose pliers
⬢2.5mm Allen key
⬢T10 torx key / T10 torx screwdriver
Contents
Prusa CORE One kit assembly (1.00)
- 1. Introduction
- 2. Base assembly
- 3. Back assembly
- Tools necessary for this chapter
- PSU assembly: parts preparation
- Preparing the PSU
- Power cables info
- Connecting the PSU
- xBuddy: parts preparation I.
- xBuddy: parts preparation II.
- Applying the thermal pads
- Installing the xBuddy
- Installing the xBuddy extension
- Installing zip ties
- Connecting the xBuddy extension board
- Inserting grommets: xBuddy box
- Wi-Fi: parts preparation
- Assembling the Wi-Fi
- Installing the Wi-Fi assembly
- Back panel: parts preparation
- Installing grommets: back panel top
- Installing grommets: sides + bottom
- Aligning the PSU
- Mounting the PSU
- Aligning the xBuddy box assembly
- Mounting the xBuddy box
- Power cables cover: parts preparation
- Connecting the power cables
- Preparing the PSU-cable-cover
- Covering the PSU cables
- Chamber fans: parts preparation
- Assembling the fan grid
- Attaching the fans
- Covering the cooling fans
- Rear profiles: parts preparation
- Installing the rear profiles
- Mounting the back panel
- Stepper splitter: parts preparation
- Guiding the Stepper splitter cable
- Connecting the Stepper splitter
- Mounting the Stepper Splitter
- LCD cable: parts preparation
- Guiding the LCD cable
- Main FE cable INFO
- Connecting the FE cable (no 3.)
- Guiding the FE cable (no. 2)
- Guiding the FE cable (no. 1)
- Guiding the FE cable (no. 4 and 5)
- FE cable - xBuddy: parts preparation
- Connecting the FE cable: xBuddy
- Plugging the xLCD cable
- PSU-cover: parts preparation
- Connecting the FE cable: PSU
- Haribo time
- Done
- 4. Heatbed assembly
- 5. CoreXY assembly
- 6. Nextruder assembly
- 7. Bodywork & Electronics
- 8. Trim, Door & xLCD
- 9. Calibration & First run
- Manual changelog
Comments
Log in to post a comment
No comments