EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

3. Nextruder disassembly

3. Nextruder disassembly

3. Nextruder disassembly
Relevant for:
Last updated a month ago
3. Nextruder disassembly
 Difficulty
Moderate
 Steps
9
 Available languages
CSPLDEESITFR
Wi-Fi antenna detaching
Wi-Fi antenna detaching
This step is only for the printer, which has a Wi-Fi antenna on the back of the printer.
Turn the printer, so the back side of the printer is facing you.
Unscrew the Wi-Fi antenna from the antenna connector and place it nearby.
PTFE unpluging
PTFE unpluging
Turn the printer so the left side of the printer is facing you.
Gently push the black collet to release the PTFE tube.
Pull out the PTFE tube.
Disconnecting the Nextruder cable
Disconnecting the Nextruder cable
Disconnecting the Nextruder cable
Disconnecting the Nextruder cable
Turn the printer, so the back side of the printer is facing you.
There is an antenna cable behind the antenna-holder, do not pull the connector!
Loosen two screws on the cover slightly. No need to remove them completely. Push the cover to the right and gently remove it from the screws.
Push the safety latch and disconnect the Nextruder cable from the connector "DWARF1".
Attach the antenna-holder to the screws and push the cover to the left. Tighten the screws.
Detaching the dock
Detaching the dock
Detaching the dock
Using a 2.5mm Allen key, untighten the screw inside the (middle hole) dock.
Keep the Nextruder cable bundle next to the printer.
Detaching the Nextruder
Detaching the Nextruder
Detaching the Nextruder
Turn the printer, so the front side is facing you.
Snap off the x-carriage-cover back from the X-carriage. Do not throw it away, we'll use it later!
Using a T10 Torx key, remove two M3x12bT screws.
Detaching the Nextruder
Detaching the Nextruder
Detaching the Nextruder
Hold the Nextruder during disassembly.
Remove two M3x12bT screws using a T10 Torx key.
Unplug the Nextruder and place it nearby, we will rebuilt it in the next steps.
Still no sweets?
Still no sweets?
Carefully and quietly open the bag with the Haribo sweets. A high level of noise might attract nearby predators!
Spread the entire contents of the bag on a clean plate and arrange them according to the picture. The color doesn't matter that much.
The total number in your package may vary slightly. However, the exact number is important. If any gummy bears are missing, please go to your nearest candy store immediately.
Eat ten gummy bears.
Did you know that gummy bears were first created by a German candy maker named Hans Riegel in the 1920s.
Good job!
Good job!
Well done, the printer is ready for the assembly. Let's go to the next chapter: 4. Nextruder upgrade
Was this guide helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us