English
1. Tools necessary for this chapter
Step 1 of 29 (Chapter 6 of 9)
Contents
Comments
⬢For this chapter, please prepare:
⬢2.0mm Allen key
⬢2.5mm Allen key
⬢T8/10 Torx key
Contents
Original Prusa i3 MK3S/MK3S+ to MK3.5 upgrade (1.0)
- 1. Introduction
- 2. Parts check
- 3. Printer dissasembly
- 4. xBuddy assembly
- 5. xLCD & PSU assembly
- 6. Heatbed upgrade
- Tools necessary for this chapter
- Removing the heatbed thermistor
- New heatbed thermistor: parts preparation
- Preparing the heatbed and thermistor
- Covering the thermistor
- Fixing the thermistor in place
- Heatbed cable assembly: parts preparation
- Heatbed cable assembly (part 1)
- Heatbed cable assembly (part 2)
- Heatbed cable assembly (part 3)
- Covering the heatbed cables: parts preparation
- Assembling the heatbed-cable-cover-bottom
- Assembling the heatbed-cable-cover: nylon filament
- Assembling the heatbed-cable-cover-bottom
- Assembling the heatbed-cable-cover-top
- Wraping the textile sleeve
- Installing the Expansion joints: parts preparation
- Preparing the expansion joints
- Installing the Expansion joints
- Attaching the heatbed: parts preparation
- Attaching the heatbed
- Tightening the heatbed
- Heatbed-cable-holder: parts preparation
- Guiding the heatbed cables
- Covering the heatbed cables
- Installing the ESP module: parts preparation
- Installing the ESP module
- Reward yourself!
- Almost there
- 7. Extruder upgrade
- 8. Preflight check
- Manual changelog MK3.5 upgrade
Comments
Log in to post a comment
smax
•
The Torx driver indicated wasn't included in the MK3S/+ kit and is not included in the MK3.5 upgrade kit, I would suggest listing the required Torx driver size so that an alternative can be used (I can't remember if it was T8 or T10. Also, the steps in this chapter reference the universal wrench, which has also not been included for MK3.5 upgraders. I'd suggest listing required wrench sizes or alternatives. The M3 nuts require a 5.5mm wrench; I'm not sure what size would be requied for holding the expansion joints.