⬢For the following steps, please prepare:
⬢Spool holder Base (4x)
⬢Spool holder Guide (1x)
⬢Spool holder Wheel (4x)
⬢Sheet of Foam Pads (1x)
EN
Login- Čeština
- Español
- Italiano
- Deutsch
- Polski
- Français
- Home
- MINI+
- Assembly manuals
- Original Prusa MINI+ kit assembly
- 6A. Spool holder assembly
6A. Spool holder assembly
Menu
- Original Prusa MINI+ kit assembly
- 1. Introduction
- 2. YZ - axis assembly
- 3. X-axis & Extruder assembly
- 4. Print head & Heatbed assembly
- 5. LCD assembly & Electronics
- 6A. Spool holder assembly
- 1. Injection molded holder: parts preparation
- 2. Base assembly (part 1)
- 3. Base assembly (part 2)
- 4. Foam pads installation (part 1)
- 5. Foam pads installation (part 2)
- 6. Adjusting the spool holder width
- 7. Spool holder assembly: reward yourself!
- 8. Spool holder is assembled!
- 6B. Spool holder assembly
- 7. Preflight check
- Manual changelog MINI+ kit
6A. Spool holder assembly
Relevant for:
Last updated a year ago Difficulty
Very easy Steps
8 Available languages
⬢Take one Base part. Arrange it as seen in the picture.
⬢Insert two wheels into the Base.
⬢Cover the assembly with another Base part on top.
⬢Push both Base parts together until they fully engage one into the other.
⬢Verify the Base parts hold together properly.
⬢Repeat the same steps for the other side part of the spool holder, until you get two of these.
⬢Take the foam pad sheet. Bend it to separate the individual foam pad strips.
⬢There is a bending line inside the inner opening on the bottom of the spoolholder side part.
⬢Attach an individual foam pad strip onto the middle of the bending line inside the opening, as seen in the picture.
⬢Attach another four foam pad strips onto the marked positions on the bottom of the spool holder side part.
⬢Install another six foam pad strips onto the other side part of the spool holder.
⬢Slide the side parts onto the Guide part.
⬢Place a spool of the filament you wish to use in the spool holder. Align the side parts to match the spool. We are using a spool of Prusament as an example.
⬢You just finished the Spool holder assembly. That was fast!
⬢Eat the fifth row.
⬢Check the final look, and compare it to the picture.
⬢That was easy, wasn't it? ;) Now it's finally time for the last chapter: 7. Preflight check
Was this guide helpful?
Comments
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.