English
1. Tools necessary for this chapter
Step 1 of 44 (Chapter 7 of 10)
Contents
Comments
⬢For the following steps, please prepare:
⬢2.5mm Allen Key
⬢1.5mm Allen Key
⬢T10 Torx Key
⬢Needle-nose Pliers
⬢Flush Cutters (Optional)
Loading...
Contents
Prusa CORE One kit assembly
- 1. Introduction
- 2. Base assembly
- 3. Back assembly
- 4. Heatbed assembly
- 5. CoreXY assembly
- 6. Nextruder assembly
- 7. Bodywork & Electronics
- Tools necessary for this chapter
- Front profiles: parts preparation
- Installing the front right profile
- Installing the front left profile
- Top profiles: parts preparation
- Assembling the top profiles I.
- Assembling the top profiles II.
- Aligning the top profiles
- Installing the top profiles
- CoreXY fixing screws: parts preparation
- Fixing the CoreXY assembly
- Side sensor base: parts preparation
- Assembling the side sensor base
- Testing the lever
- Installing the magnets
- IR Sensor: parts preparation
- Connecting the IR sensor
- Installing the IR sensor
- Installing the side sensor cover
- Side filament sensor: parts preparation
- Installing the side filament sensor
- Guide the filament sensor cable
- Connecting the side filament sensor
- NFC Antenna: parts preparation
- Applying the adhesive film
- Installing the NFC Coil
- Connecting the NFC Coil
- Wiring check
- Preparing the electronics cover
- Installing the electronics cover
- Buddy3D Camera Note
- xBuddy cover: parts preparation
- Installing the xBuddy cover
- Installing the rear cover
- Right side: parts preparation
- Installing the spool holder
- Right handle: parts preparation
- Installing the collet
- Mounting the handle
- Fixing the right side
- Left side: parts preparation
- Installing the left side
- Haribo time
- Done
- 8. Trim, Door & xLCD
- 9. Calibration & First run
- Manual changelog
Comments
Log in to post a comment
William Clark
•
The torx screwdriver is the goat. It seems to work with the hex and torx screws. The other screwdriver seems to fail in every way it can. My orange screwdriver did its best to not strip the screw but strip the head of the screwdriver.
Reply
ky
•
it was here that i realized that the screwdriver was a torx key
Reply