English
1. Before you start with Multi-Tool
Step 1 of 30 (Chapter 7 of 8)
Contents
Comments
This chapter shows a brief description of the wizard. Please note that the screenshots are illustrative and might differ from those in the firmware.
Make sure you are running Firmware 4.7.0 or newer
You can download firmware updates in Downloads. The guide for updating the firmware is in How to update firmware (MK4/XL)
Some parts of the wizard must be done multiple times, this depends on the number of tool-heads. For example:
⬢Dock Calibration
⬢Loadcell calibration
⬢Filament sensor calibration
Contents
Original Prusa XL Single-Tool to Dual-Head Upgrade (1.01)
- 1. Introduction
- 2. Printer preparing
- 3. Nextruder disassembly
- 4. Nextruder upgrade
- 5. ToolChanger assembly
- 6. Nextruder & accessories assembly
- 7. First run
- Before you start with Multi-Tool
- Preparing the printer
- Factory reset
- Prusa Nextruder sock (Optional)
- Wizard
- Wizard: Dock Position Calibration
- Wizard: Loosen pin
- Wizard: Loosen screws
- Wizard: Lock the tool
- Wizard: Tighten the upper screw
- Wizard: Tighten the lower screw
- Wizard: Install pins
- Wizard: Dock successfully calibrated
- Wizard: Test Loadcell
- Wizard: Recalibrate Filament Sensors
- Wizard: Recalibrate Filament Sensors
- Wizard: Recalibrate Filament Sensors
- Calibration pin: parts preparing
- Calibration pin: parts assembly
- Wizard: Tool Offset Calibration
- Wizard: Sheet install
- Wizard: Calibration pin installation
- Wizard: Offset calibration done
- Calibration pin
- It's done
- Reward yourself!
- Quick guide for your first prints
- Printable 3D models
- Prusa knowledge base
- Join Printables!
- Manual changelog (Single-Tool to Dual-Head Upgrade)
Comments
Log in to post a comment
No comments