English
1. Tools necessary for this chapter
Step 1 of 22 (Chapter 10 of 14)
Contents
Comments
⬢Needle-nose pliers for the heatbed assembly
⬢2.5mm Allen key for M3 screws
⬢2mm Allen key for heatbed alignment
Contents
Original Prusa i3 MK3 kit assembly
- 1. Introduction
- Introduction
- 2. Y-axis assembly
- 3. X-axis assembly
- 4. Z-axis assembly
- 5. E-axis assembly (spiral wrap)
- 5. E-axis assembly (textile sleeve)
- 6. LCD assembly
- 7. Heatbed & PSU assembly (spiral wrap)
- 7. Heatbed & PSU assembly (textile sleeve)
- Tools necessary for this chapter
- Different heatbed versions
- Heatbed cable assembly (part 1)
- Heatbed cable assembly (part 2)
- Heatbed cable assembly (part 3)
- Preparing the heatbed
- Preparing the heatbed-cable-cover
- Mounting the heatbed-cable-cover
- Proper cable management
- Wrapping the heatbed cables
- Securing the sleeve in place
- Finalizing the wrap
- Preparing the heatbed screws and spacers
- Mounting the heatbed (part 1)
- Mounting the heatbed (part 2)
- Mounting the heatbed (part 3)
- Mounting the heatbed (part 4)
- Preparing the PSU
- Assembling the PSU (part 1)
- Assembling the PSU (part 2)
- Heatbed and PSU are done!
- Different versions of the Einsy-base
- 8. Electronics assembly (B3/R2 design)
- 8. Electronics assembly (B7/R3 design)
- 9. Preflight check
- Manual changelog
Comments
Log in to post a comment
Eyal Peleg
•
I would suggest that this stage clearly states (Again) that this entire guide is for you only if you have a textile wrap and a spiral wrap.
if you do not have the textile wrap but have a two spiral wraps instead, you should go back and choose the other number 7 guide,
i.e. the one titled “'''7. Heatbed & PSU assembly (spiral wrap)'''“'''.'''
if you do not have the textile wrap but have a two spiral wraps instead, you should go back and choose the other number 7 guide,
i.e. the one titled “'''7. Heatbed & PSU assembly (spiral wrap)'''“'''.'''