1. Tools necessary for this chapter

Original Prusa XL Single-Tool to Five-Head Upgrade (1.01)

• 1. Introduction
• 2. Printer preparing
• 3. Detaching the Nextruder
• 4. ToolChanger assembly
• 5. Nextruder upgrade
• 6. PSU & electronics assembly
• 7. Nextruder & accessories assembly
  1. Tools necessary for this chapter
  2. Filament sensor: parts preparation
  3. Right filament sensor
  4. Nextruder cable: parts preparation
  5. Guiding the Nextruder cable
  6. Attaching the Nextruder docks
  7. Dock inspection
  8. Dock inspection: video
  9. Connecting the Nextruder cables
  10. Wi-fi antenna holder versions
  11. Installing the rear Wi-Fi antenna holder
  12. Connecting the side Wi-Fi antenna
  13. Connecting the Nextruder cables
  14. XL buddy box covering
  15. Guiding the docks PTFE tubes
  16. Guiding the docks PTFE tubes
  17. Installing the Wi-Fi antenna: parts preparation
  18. Installing the Wi-Fi antenna
  19. Spool holder: parts preparation
  20. Assembling the spool holder
  21. Preparing the spool holder
  22. Spool holder: left side assembly
  23. Spool holder: right side assembly
  24. Nextruder assembly: parts preparation
  25. Docking the Nextruder
  26. Nextruder cable bundle assembly
  27. Nextruder cable bundle assembly
  28. Nozzle seal height calibration
  29. Nozzle seal height calibration
  30. Haribo time!
  31. Remaining fasteners
  32. Almost done!
• 8. First run
• Manual changelog XL (Single-head to Five-head upgrade)