English
1. Tools necessary for this chapter
Step 1 of 41 (Chapter 12 of 14)
Contents
Comments
⬢Needle-nose pliers for zip tie trimming.
⬢2.5mm Allen key for M3 screws
⬢1.5mm Allen key for nut alignment
⬢Philips screwdriver to tighten PSU and HB cables
Contents
Original Prusa i3 MK3 kit assembly
- 1. Introduction
- Introduction
- 2. Y-axis assembly
- 3. X-axis assembly
- 4. Z-axis assembly
- 5. E-axis assembly (spiral wrap)
- 5. E-axis assembly (textile sleeve)
- 6. LCD assembly
- 7. Heatbed & PSU assembly (spiral wrap)
- 7. Heatbed & PSU assembly (textile sleeve)
- 8. Electronics assembly (B3/R2 design)
- 8. Electronics assembly (B7/R3 design)
- Tools necessary for this chapter
- Preparing the Einsy-door (part 1)
- Preparing the Einsy-door (part 2)
- Identifying mount holes
- Preparing the lower hinge
- Einsy-door assembly
- Wrapping X-axis cable
- Preparing the Einsy-base (part 1)
- EINSY RAMBo board - different versions
- Preparing the Einsy-base (part 2)
- Preparing the Einsy-base (part 3)
- Mounting the Einsy-base (part 1)
- Mounting the Einsy-base (part 2)
- Mounting the Einsy-base (part 3)
- Cable management (part 1)
- Cable management (part 2)
- Cable management (part 3)
- Cable management (part 4)
- Cable management (part 5)
- Cable management (part 6)
- Cable management (part 7)
- Cable management (part 8)
- Connecting cable bundles
- Connecting the heatbed cable bundle
- PSU and HB power cables (part 1)
- PSU and HB power cables (part 2)
- Connecting all motors (X/Y/Z axis)
- PSU power panic and HB thermistor
- Connecting the extruder cable bundle (part 1)
- Wrapping the cable bundle
- Connecting the extruder cable bundle (part 2)
- Connecting the extruder cable bundle (part 3)
- Connecting the extruder cable bundle (part 4)
- Connecting the LCD cables
- Verify all connections once more!
- Finalizing the Einsy cover
- Mounting antivibration feet
- Assembling the double spool holder (part 1)
- Assembling the double spool holder (part 2)
- Mounting the double spool holder
- Hooray!
- 9. Preflight check
- Manual changelog
Comments
Log in to post a comment
No comments