1. Tools necessary for this chapter

Prusa CORE One+ conversion kit (1.02)

• 1A. Introduction
• 1B. MK4S Inspection
• 1C. Printer Disassembly
• 1D. Component Prep
• 2. Base assembly
• 3. Back assembly
• 4. Heatbed assembly
• 5. CoreXY assembly
• 6. Nextruder assembly
• 7. Bodywork & Electronics
• 8. Trim, Door & xLCD
  1. Tools necessary for this chapter
  2. Top cover: parts preparation
  3. Removing the foil
  4. Test-fitting the top cover
  5. Assembling the top cover I.
  6. Assembling the top cover II.
  7. Testing the ventilation
  8. Installing the top cover
  9. Side covers: parts preparation
  10. Removing the foil
  11. Covering the left side
  12. Covering the right side
  13. xLCD: parts preparation
  14. Important: new xLCD display mount
  15. Assembling the xLCD I.
  16. Assembling the xLCD II.
  17. Installing the FE Faston connector
  18. Installing the LCD knob
  19. xLCD bezel: parts preparation
  20. Mounting the xLCD I.
  21. Mounting the xLCD II.
  22. Installing the xLCD assembly
  23. Securing the xLCD assembly
  24. Door seal: parts preparation
  25. Attaching the top seal
  26. Attaching the side seals
  27. Magnet holders: parts preparation
  28. Assembling the magnet holders
  29. Installing the magnet holders
  30. Hinges: parts preparation
  31. Installing the door-hinge-in parts
  32. Installing the door-hinge-out I.
  33. Installing the door-hinge-out II.
  34. Door panel: parts preparation
  35. Important: new parts
  36. Door panel: removing the protective film
  37. Door handle installation method selection
  38. Installing the door handle (srew-mounted)
  39. Securing the handle (srew-mounted)
  40. Installing the door panel
  41. Assembling the door handle (glued version)
  42. Securing the door handle (glued version)
  43. Attaching the sticker: Parts preparation
  44. Attaching the sticker
  45. Haribo time
  46. Done
• 9. Calibration & First run
• Manual changelog