English
1. Tools necessary for this chapter
Step 1 of 39 (Chapter 8 of 10)
Contents
Comments
⬢For the following steps, prepare:
⬢2.5mm Allen Key
⬢T10 Torx Key
⬢Needle-nose pliers
Contents
Prusa CORE One kit assembly (1.00)
- 1. Introduction
- 2. Base assembly
- 3. Back assembly
- 4. Heatbed assembly
- 5. CoreXY assembly
- 6. Nextruder assembly
- 7. Bodywork & Electronics
- 8. Trim, Door & xLCD
- Tools necessary for this chapter
- Top cover: parts preparation
- Removing the foil
- Test-fitting the top cover
- Assembling the top cover I.
- Assembling the top cover II.
- Testing the ventilation
- Installing the top cover
- Side covers: parts preparation
- Removing the foil
- Covering the left side
- Covering the right side
- xLCD: parts preparation
- Assembling the xLCD I.
- Assembling the xLCD II.
- Installing the FE Faston connector
- Installing the LCD knob
- xLCD bezel: parts preparation
- Mounting the xLCD I.
- Mounting the xLCD II.
- Installing the xLCD assembly
- Securing the xLCD assembly
- Door seal: parts preparation
- Attaching the top seal
- Attaching the side seals
- Magnet holders: parts preparation
- Assembling the magnet holders
- Installing the magnet holders
- Hinges: parts preparation
- Installing the door-hinge-in parts
- Installing the door-hinge-out I.
- Installing the door-hinge-out II.
- Door panel: parts preparation
- Door panel: removing the protective film
- Installing the door panel
- Assembling the door handle
- Securing the door handle
- Haribo time
- Done
- 9. Calibration & First run
- Manual changelog
Comments
Log in to post a comment
No comments