English
1. Begin assembly
Step 1 of 19 (Chapter 1 of 1)
Contents
Comments
Contents
Octoprint
- Octoprint setup on MK4/S, MK3.9/S, MK3.5/S, XL, CORE
- Begin assembly
- Introduction
- Parts preparation: Raspberry Pi
- Preparing necessary software
- Setting up the SD card in Pi Imager
- Setting up the SD card in Pi Imager 2
- Setting up the SD card in Pi Imager 3
- Inserting the SD card
- Connecting the RPi to the printer
- Powering up the Raspberry Pi
- Finding out the IP Address
- Octoprint Wizard setup
- Printer profile setup
- Setting up special G-codes
- Connecting the Octoprint to the printer
- Uploading a G-code and starting a print
- Printing using Octoprint
- A few extra notes
- Optional: Installing Plugins
Comments
Log in to post a comment
96ToyotaCamry
•
Would this tutorial for Octoprint also work for the CoreONE? (I assume yes, as the MK4S and the CoreONE use the same Controller Card?
Reply
Fnord Prefect
•
I think it is fair to say that PrusaLink is in fact a 1st party alternative to OctoPrint. ;-)
Reply