• English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français

Boot slot changed #10601 (SL1/SL1S)

Relevant for:
Last updated 3 years ago
This article is also available in following languages: 

What happened?

The printer is displaying the message: The printer has booted from an alternative slot due to failed boot attempts using the primary slot. Update the printer with up-to-date firmware ASAP to recover the primary slot. This usually happens after a failed update, or due to a hardware failure. Printer settings may have been reset.

Error name: Boot slot changed 

Error code: #10601

How to fix it?

Try to flash the firmware again. Try to avoid using OTA flashing as your network can be a factor. If it persists, it may indicate an issue with the on-board eMMC storage and the board may need to be replaced. If so, please contact support.


Firmware updating (SL1)

Was this article helpful?


Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us