Loadcell Bad Configuration
#17527 (XL)
関連するもの
XL
記事 他の言語でもご覧になれます。
関連するもの
The Original Prusa XL is equipped with a loadcell, to detect that the nozzle is close enough to the steel sheet for printing, and to avoid damage that would be caused by the nozzle digging into the steel sheet.
In case the printer detects an incorrect loadcell configuration, but not related to the loadcell tare, or to the loadcell calbiration, the printer wil show the message: "The loadcell configuration is incorrect."
Error name: Loadcell Bad Configuration
Error code: #17527
Open the dwarf-cover-door to access the Dwarf board. The loadcell connector is on the bottom left, check it for any loose cable, disconnected cable, or visible damage.
 |  |
Navigate to LCD Menu - Control - Calibration and test - Loadcell test to restart the loadcell calibration.
During the test, you will be asked to tap the nozzle at a specific time, and a progress bar on top of the screen will be filled. If the progress bar is not filled or the printer shows any errors, please contact our customer support.