Status LED explained (MMU3)

This article is also available in following languages: 

This article is describing the status of the LEDs located on the multi material unit. Together there are five LEDs on the unit that correspond to the five available filament positions. 

During the regular MMU operation: 

• GREEN solid light: The MMU has a record of the given filament being loaded in the extruder.
• GREEN flashing light: There is a loading/unloading process going on.
• RED flashing light: There is a loading/unloading error with the given filament. The unit is waiting for user interaction.
• RED and GREEN flashing lights: Internal runtime error, refer to the error shown on the printer’s LCD.

MMU Firmware start:

After the MMU unit has been turned on or restarted, green LEDs light up from positions 5 to 1 shortly (~100ms). Each signalizes one component up and running: 

• LED 5: Shift registers initialization
• LED 4: USART initialization
• LED 3: SPI communication initialization
• LED 2: motion system initialization
• LED 1: ADC initialization

If the MMU stops in this setup phase (the LEDs stay on and do not turn off), something is wrong with the electronics.

Then, a selftest routine is performed. It checks if the main control board behaves correctly and if all the signals from the microcontroller get to the TMC motor drivers on the control board properly. If the MMU unit suspects the communication with any of the three TMC motor drivers might not behave correctly, an error is shown. In that case, refer to the printer’s LCD screen.

LED lights indicate the ongoing phases of the selftest routine:

• LED 1: ok (green) / error (red) on STEP signal
• LED 2: ok (green) / error (red) on DIR signal
• LED 3: ok (green) / error (red) on ENABLE signal
• LED 4 indicates which TMC driver is being tested
  • Idler = green
  • Selector = red
  • Pulley = green+red
• LED 5 is flashing green while the process is still ongoing.

Other LED lights on the unit: 

There are also other less important LED indicators on the unit.

• A green LED on the MMU3 PD-board addon, on the back of the unit. It signalizes the board receiving power from the printer.
• An orange indicator "breathing" on the inside of the MMU unit, on the main control board, signalizes the electronics booting up.
• A red indicator on the top of the FINDA sensor signalizes the sensor being powered up and NOT detecting a filament.