English
1. Tools necessary for this chapter
Step 1 of 30 (Chapter 7 of 9)
Contents
Comments
⬢For this chapter, please prepare:
⬢2.5mm Allen key
⬢Needle nose pliers
⬢Safety glasses (not included in the kit)
Safety glasses will need to be worn when shortening the nylon filament. It is not necessary to put the glasses on immediately. You will be prompted in time.
Contents
Original Prusa i3 MK3S/MK3S+ to MK3.5S upgrade (1.0)
- 1. Introduction
- 2. Parts check
- 3. Printer dissasembly
- 4. xBuddy assembly
- 5. xLCD & PSU assembly
- 6. Heatbed upgrade
- 7. Extruder & connectivity upgrade
- Tools necessary for this chapter
- Removing the nylon filament
- New nylon filament: parts preparation
- Cutting the nylon filament
- Inserting the nylon
- Wrapping the cable bundle
- Guiding the cable bundle
- Ext-cable-holder: parts preparation
- Attaching the Ext-cable-holder
- Assembling the Ext-cable-holder
- Attaching the extruder cable bundle
- Connecting the X motor cable
- MK3.5 adapter cable: parts preparation
- MK3.5 adapter cable connecting (part 1)
- MK3.5 adapter cable connecting (part 2)
- MK3.5 adapter cable connecting (part 3)
- MK3.5 adapter cable connecting (part 4)
- NFC antenna: parts preparation I.
- NFC antenna: parts preparation II.
- Preparing the NFCcoil
- Assembling the NFC antenna
- Connecting the NFC antenna
- Verify all connections once more!
- Covering the xBuddy box: bottom cover
- Covering the xBuddy box
- Labels: parts preparation
- Upgrading the safety label (optional)
- SN label (required)
- Haribo time!
- Good job!
- 8. Preflight check
- Manual changelog MK3.5S upgrade
Comments
Log in to post a comment
No comments