⬢Plug-in the printer. If display is on, everything is fine ;-)
⬢Notice the squished filament line around the PRUSA logo. This is the right amount of compression for the first layer.
⬢Prepare the printbed.
ES
Iniciar sesión- English
- Home
- Plus 1.75 mm
- Manuales de montaje
- Montaje del kit de la Original Prusa i3 Plus 1.75 mm
- First print i3 Plus LCD/SD
First print i3 Plus LCD/SD
Menu
- Montaje del kit de la Original Prusa i3 Plus 1.75 mm
- Calibrate i3 Plus LCD/SD
- Introduction
- First print i3 Plus LCD/SD
- 1. Plug in the printer
- 2. Spool holder
- 3. Preheat the printer
- 4. Filament change
- 5. Clean the nozzle
- 6. Start the print
- 7. Check the first layer
First print i3 Plus LCD/SD
Relevante para :
Ultima actualización 2 years ago Dificultad
Moderada Pasos
7 Idiomas disponibles
⬢Snap the filament holder arms on the printer as seen on picture.
⬢Put the filament spool in by spreading the arms a bit.
⬢Filament must go towards you on the top side.
⬢Check if the filament is not coming out of the sides of the spool, if so, snip it.
⬢Preheat for ABS first as we test the printer with ABS. For later prints you can use preheat for PLA.
⬢Wait for the printer to heat up.
⬢On heated printer, grab the filament poking out of the extruder and with your other had rotate the big gear counter-clockwise until it completely comes out.
⬢Insert the end of the material into the hole and push while rotating the big gear clockwise until you see a little extrusion at the nozzle tip.
⬢Always check if the filament has nice sharp edge on the end for smooth insertion.
⬢This can be done with software, but by using your hand you can easily feel if the filament extrudes smoothly.
⬢Clean the nozzle before printing from any extrusion. I used the test logo print.
⬢In the menu choose Print from SD and PRUSA.gcode
⬢Printer will make a thick line on the side. This equalises the flow of plastic.
⬢Then printer will print so-called 'skirt' around. If it is nicely squished, you've done your calibration right!
⬢First layer is cruical so always watch the printer if the first layer is printed correctly.
¿Fue útil esta guía?
Comentarios
¿Todavía tienes preguntas?
Si tienes alguna pregunta sobre algo que no se ha tratado aquí, comprueba nuestros recursos adicionales.
Y si eso no lo soluciona, puedes enviar una petición a [email protected] o mediante el botón que hay más abajo.