English
1. Tools necessary for this chapter
Step 1 of 34 (Chapter 4 of 9)
Contents
Comments
⬢For this chapter, please prepare:
⬢2.5mm Allen key
⬢Needle-nose pliers
Contents
Original Prusa MK4 kit assembly (1.01)
- 1. Introduction
- 2. Frame assembly
- 3. X-axis & X-carriage assembly
- 4. Z-axis assembly
- Tools necessary for this chapter
- Assembling the Z-bottoms: parts preparation
- Assembling the Z-bottoms
- Z motor assembling: parts preparation
- Attaching the rubber pads
- Installing the Z motors
- Connecting the Z motors
- Mounting the X-axis assembly: parts preparation
- Mounting the X-axis and smooth rods
- Assembling the X-axis and smooth rods
- Installing the X-axis assembly
- Assembling the trapezoidal nuts
- Installing the Z-top parts: parts preparation
- Placing the Z-top parts
- LoveBoard: parts preparation
- Assembling the LoveBoard
- Connecting the extruder main cable
- Mounting the extruder main cable
- Connecting the extruder main cable: parts preparation
- Connecting the extruder main cable
- Covering the X-carriage: parts preparation
- Covering the X-carriage: inserting the nylon filament
- Attaching the X-cover-back
- Guiding the main-cable: parts preparation
- Wrapping the extruder main cable
- Wrapping the textile sleeve
- Attaching the Ext-cable-holder: parts preparation
- Wrapping the X motor cable
- Attaching the Ext-cable-holder
- Assembling the Ext-cable-holder
- Covering the Ext-cable-holder
- Mounting the Ext-cable-holder
- Reward yourself!
- Here it is!
- 5. Nextruder assembly
- 6. xLCD assembly
- 7. Y-carriage & Heatbed assembly
- 8. Preflight check
- Manual changelog MK4 kit
Comments
Log in to post a comment
Sridhar Rajagopal
•
Were the needle-nose pliers used in any steps here? I didn't really see it! I did use it (as I have done in previous steps) to hold the M3NS nut to insert into slots! :-)
Barry A
•
A set of ball head screw drivers will help a great deal in placing the hundreds of screws in the kit.