English
1. Begin assembly
Step 1 of 28 (Chapter 34 of 39)
Contents
Comments
Contents
Printer maintenance
- How to replace the CoreXY plastic parts
- How to replace the main cable connector cover (XL)
- How to change the belt (XL)
- Packing the XL Enclosure for return - Original Packing material
- How to install the Nextruder V6 Nozzle Adapter (XL single-tool)
- How to replace the Prusa Nozzle (XL single-tool)
- How to replace the Hotend assembly (XL single-tool)
- Packing printer for transport - Original Packing Material (XL)
- How to replace a XY motor (XL)
- How to replace the Prusa Nozzle (XL multi-tool)
- How to replace a Z-axis motor (XL)
- Packing the XL Multi-tool for return - Original Packing material
- How to replace a heatbed tile and a heatbed tile cable (XL)
- How to replace a print fan (XL single tool)
- How to fix Modular bed error (HW solution)
- How to replace trapezoid nuts (XL)
- How to clean the side filament sensor (XL)
- How to change xLCD and xLCD cable (XL single-tool)
- How to replace a Dwarf board (XL multi-tool)
- How to replace Nextruder heatsink (XL Multi-tool)
- How to replace a Dwarf board (XL single-tool)
- How to replace the Hotend assembly (XL multi-tool)
- How to replace a hotend thermistor (XL Single-Tool)
- How to replace a Z-axis linear rail (XL)
- How to replace a profile insert (XL)
- How to replace the hotend fan (XL Multi-tool)
- How to replace a PSU (XL)
- How to replace a hotend heater (XL Single-Tool)
- How to lubricate the coupler pins on Original Prusa XL (Multi-Tool)
- How to replace the tch-profile-insert (XL)
- How to replace the Sandwich Board (XL)
- How to replace the rubber band on Original Prusa XL (Multi-tool)
- How replace the CoreXY Cover Rear (Original Prusa XL)
- How to install the Nextruder V6 Nozzle Adapter (XL Multi-Tool)
- Begin assembly
- Introduction
- Handling Hot Components Safely
- Tools necessary for this chapter
- Select the tool
- Filament unloading
- Cleaning the hotend
- Park the tool
- Preparing the printer
- Undocking the Nextruder
- Disconnecting the hotend
- Removing the hotend
- Removing the Prusa Nozzle
- Installing the V6 nozzle: parts preparation
- Installing the Nextruder V6 Nozzle Adapter
- Installing the hotend
- Turning the printer ON
- Heating the nozzle
- Tightening the nozzle
- Adjusting the hotend
- How to dock the Nextruder
- Setting the nozzle diameter
- Tool Offset Calibration
- Tool Offset Calibration - Sheet install
- Tool Offset Calibration - pin installation
- Tool Offset Calibration - Done
- Calibration pin
- It's done
- How to change the xLCD (XL)
- How to lubricate linear bearing rails (XL)
- How to set up a Buddy3D Cam
- How to replace Nextruder heatsink (XL Single-tool)
- How to replace a Nextruder (XL)
Comments
Log in to post a comment
No comments