English
1. Begin assembly
Step 1 of 37 (Chapter 14 of 23)
Contents
Comments
Contents
Printer maintenance
- How to replace a M.I.N.D.A. sensor (MINI)
- How to replace a print fan (MINI)
- How to replace a hotend PTFE tube (MINI/MINI+)
- How to replace a hotend fan (MINI)
- How to replace a heatsink (MINI/MINI+)
- How to replace a heaterblock/heatbreak (MINI/MINI+)
- How to replace a Buddy control board (MINI)
- How to access and clean the extruder-pulley (MINI/MINI+)
- How to update firmware (MINI/MINI+)
- How to replace a print head PTFE tube (MINI/MINI+)
- How to replace a heatbed thermistor (MINI/MINI+)
- How to replace a hotend thermistor (MINI/MINI+)
- Height adjustment of M.I.N.D.A./SuperPINDA sensor (MINI/+)
- How to replace a hotend heater (MINI/MINI+)
- Begin assembly
- Introduction
- Tools necessary for this guide
- Preparing the printer
- Opening the box with the electronics
- Disconnecting the heater
- New vs old design
- Removing the textile sleeve (new design)
- Removing the fan-spacer-clip (new design)
- Removing the heater (new design)
- Removing the heater (new design)
- Removing the Molex connector (new design)
- New hotend heater - parts preparation (new design)
- New hotend heater preparation (new design)
- Hotend heater installation (new design)
- Mounting the minda-holder (new design)
- Guiding the cable bundle (new design)
- Guiding the cable bundle (new design)
- Guiding the cable bundle (new design)
- Connecting the hotend heater (new design)
- Covering the electronics (new design)
- Removing the textile sleeve (old design)
- Removing the M.I.N.D.A. sensor (old design)
- Removing the hotend heater (old design)
- Removing the Molex connector (old design)
- New hotend heater - parts preparation (old design)
- New hotend heater preparation (old design)
- Hotend heater installation (old design)
- Mounting the minda-holder (old design)
- Guiding the cable bundle (old design)
- Guiding the cable bundle (old design)
- Guiding the cable bundle (old design)
- Connecting the hotend heater (old design)
- Covering the electronics (old design)
- M.I.N.D.A. sensor height adjustment (old design)
- Final check
- It’s done!
- How to replace a heatbed (MINI/MINI+)
- How to replace an extruder motor (MINI/MINI+)
- How to replace SuperPINDA (MINI/MINI+)
- How to replace bearings on the X-axis (MINI/MINI+)
- How to replace bearings on the Y-axis (MINI/MINI+)
- How to replace a heatbed set (MINI/MINI+)
- How to post-process the printed parts
- How to trim PTFE tube - Original Prusa printers
- Replacing the PEI sheet on the (MK3S/MK3/MK2.5S/MK2.5)
Comments
Log in to post a comment
No comments