English
1. Begin assembly
Step 1 of 14 (Chapter 2 of 23)
Contents
Comments
Contents
Printer maintenance
- How to replace a M.I.N.D.A. sensor (MINI)
- How to replace a print fan (MINI)
- Begin assembly
- Introduction
- Tools and fasteners necessary for this guide
- Protecting the heatbed
- Opening the box with the electronics
- Removing of the sleeve
- Removing the print fan
- Print fan - parts preparation
- Print fan installation
- Guiding the cable bundle
- Guiding the cable bundle
- Guiding the cable bundle
- Connecting the new print fan
- Covering the electronics
- How to replace a hotend PTFE tube (MINI/MINI+)
- How to replace a hotend fan (MINI)
- How to replace a heatsink (MINI/MINI+)
- How to replace a heaterblock/heatbreak (MINI/MINI+)
- How to replace a Buddy control board (MINI)
- How to access and clean the extruder-pulley (MINI/MINI+)
- How to update firmware (MINI/MINI+)
- How to replace a print head PTFE tube (MINI/MINI+)
- How to replace a heatbed thermistor (MINI/MINI+)
- How to replace a hotend thermistor (MINI/MINI+)
- Height adjustment of M.I.N.D.A./SuperPINDA sensor (MINI/+)
- How to replace a hotend heater (MINI/MINI+)
- How to replace a heatbed (MINI/MINI+)
- How to replace an extruder motor (MINI/MINI+)
- How to replace SuperPINDA (MINI/MINI+)
- How to replace bearings on the X-axis (MINI/MINI+)
- How to replace bearings on the Y-axis (MINI/MINI+)
- How to replace a heatbed set (MINI/MINI+)
- How to post-process the printed parts
- How to trim PTFE tube - Original Prusa printers
- Replacing the PEI sheet on the (MK3S/MK3/MK2.5S/MK2.5)
Comments
Log in to post a comment
No comments