JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login
Menu
Relevant for:
Last updated 3 years ago
This article is also available in following languages: 
ENCSPLDEESITFR

What happened?

The printer is displaying the message: Measured resin volume is too low. The print can continue, however, a refill might be required.

Warning name: Resin low

Warning code: #10712

This warning is shown to let you know that the resin will run out before the end of the print. If this is ignored, eventually error Not enough resin #10706 will stop the print.

How to fix it?

Refill the resin tank to the amount recommended initially for the print. Be careful to not overfill the tank.

If possible, fill enough resin for the entire print before starting it. Refilling resin mid-print may cause artifacts.

Was this article helpful?

Comments

Related

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us