ESP error #17506 (XL)

Relevant for:

Last updated 2 years ago

This article is also available in following languages:

What happened?

The printer is showing the message: "Unknown error"

Error name: ESP unknown error

Error code: #17506

On the Original Prusa XL, the XLBuddy board includes a WiFi module, the ESP32. needed to achieve WiFi connectivity. The error is triggered in case the printer detects an undefined problem with the ESP32 board.

How to fix it?

Re-flash firmware

The firmware needed for the ESP32 module is included in the XL firmware file. Download the firmware and if necessary the bootloader, and transfer it to your USB drive. Make sure to unmount the drive from your operating system before physically removing it.

Insert the USB drive back into the printer and reboot the printer using the reset button directly next to the knob to initiate the flashing procedure. In case the procedure does not start, reboot the printer again by pressing the same reset button, and while the printer is booting up, press once the rotating knob.

The printer will let you know when the flashing is done. When installing the bootloader along with the firmware, it may take several minutes.

A visual inspection

Before accessing any of the electronic boards, ensure that the printer is fully cooled down, and switched off for at least 10 minutes.

Access the XLBuddy board, and locate the ESP32 module. Inspect the ESP32 board for any visible damage.

Are you still having issues? Contact our support team and let them know that you tried to fix the issue with these instructions. We will take it from there.

Was this article helpful?

Easy to understand

Solved my problem

Other reason

Comments

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.