EN
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Modular Bed Error #17319 (XL)

Menu
Relevant for:
Last updated 2 years ago
This article is also available in following languages: 
PLDEESITFR

What happened?

The Original Prusa XL can detect a power fault on the Modular Bed, with hardware measurements: in case this happens, the printer will show the message "Power failure".

Error name: Modular Bed Error

Error code: #17319

How to fix it? 

A visual inspection

Before accessing any of the electronic boards, ensure that the printer is fully cooled down, and switched off for at least 10 minutes

Inspect the modular bed for physical damage, such as scratches on any of the heatbed tiles surface. 

Inspect the wiring between the Sandwich board and the Modular Bed for a loose connection, or a broken cable.  

In case of any further doubts, do not hesitate to contact our customer support.
Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us