EN
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Filament change #04508 (MMU)

Menu
Relevant for:
Last updated 9 months ago
This article is also available in following languages: 
PLDEITFR

What happened?

This error happens when the filament change function is triggered. This can happen by:

  • Filament change command in the printer’s menu.
  • Issuing the M600 G-code command.
  • The printer detects a depleted filament (when the Spooljoin function is off).

How to proceed?

Remove the old filament from the MMU unit and replace it with a new one. Click the option Load and select the desired filament position. You can select the one you previously used or a new position.

In case you need to eject the depleted filament out of the front of the MMU unit, select Eject. The Selector will move until the filament slot is free, and the filament will be ejected to the front so that you can pull it out easily.

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us