EN
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語
Login

Patterns - set extruder sequence

Relevant for:
Last updated 2 months ago
This article is also available in following languages: 
CSPLESDEITFRJA

PrusaSlicer lets you define a repeating pattern of color changes. You can access this feature by clicking the gear icon in the bottom right corner of the preview screen.

The color change interval can be defined either in layers or in millimeters - which can be useful when you’re using the Variable layer height function.

To remove all of the color changes use the reset button located in the bottom right corner of the preview screen.

You can repeat the same color (extruder) in the sequence several times.

 
Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us