How to assemble the Prusa Face Shield - RC2/RC3

This article covers how to configure your own image for any Raspberry Pi (RPi) from scratch. Following this article, you will have connected a base installation of Octoprint which you ...
The Original Prusa i3 printers use the E3D V6 Hotend. Any nozzle that is compatible with the E3D V6 Hotend can be installed on it. The stock nozzle that accompanies ...
Our printers come equipped with a standard E3D 0.4 mm brass nozzle. However, there is a whole ecosystem of nozzles with different characteristics on the market. If you need to change ...
Raspberry Pi Zero W has no 5GHz Wi-Fi (only 2.4GHz), and a somewhat weak processor. It does not support using a large amount of Octoprint-plugins or streaming of video and ...
This article will guide you through the replacement of the nozzle on your Original Prusa MINI printer. Note that this requires you to have some tools available and also be ...
ATTENTION: Don't copy/paste the information below, always link to this article. The information is subject to change. About the Prusa Face Shield The 3D-printable face shield is a reaction to the urgent ...
Octoprint is an open-source system for remotely controlling and monitor your printer. Start/stop/pause prints, change printing temperatures and settings while printing, stream video, or captures images during printing. It does ...
Prusa Research does not develop or provide support for this system! We can only address direct errors in this guide and improve clarity based on comments. Our technical/customer support can ...
Prusa Research does not develop or provide support for this system! We can only address direct errors in this guide and improve clarity based on comments. Our technical/customer support can ...
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.