- Čeština
- Español
- Italiano
- Deutsch
- Polski
- Français
- 1.75 mm
- Belt tension
- Blade
- Bondtech gears
- Bowden tube
- Buddy board
- Cantilever
- Check the cables
- Chimney (IR-sensor-holder-mmu2s)
- Control buttons
- Controller board (MMU2S)
- Curing / solidifying
- Einsy RAMBo board
- Ethernet port
- Extruder (i3)
- Extruder / Extruder motor (Mini)
- Extruder PTFE tube (Bowden-tube)
- F.I.N.D.A. sensor
- FEP foil
- FFF/FDM
- Filament
- Filament buffer
- Filament tip
- Firmware
- Flexible steel sheet
- Heatbed
- Heater block
- Heater cartridge
- Heatsink
- Hollowing
- Hotend
- Hotend fan
- Idler motor
- Idler screw
- Idler tension-screws
- Indicator LEDs
- IR filament-sensor
- Knob
- LCD screen (Mini)
- Lid
- Liquid resin
- Live adjust Z
- M.I.N.D.A. sensor
- Mesh bed leveling
- Micro USB port
- MMU Idler
- Nozzle
- Object / part manipulation panel
- Octoprint
- Olive
- Original Prusa MK2.5S
- P.I.N.D.A. sensor
- Place on Face
- Power Button (SL1)
- Power switch
- Print display
- Print fan
- Print head
- Print platform
- Print speed
- Pulley motor
- Reset button
- SD card
- Selector
- Selector Knob (MINI)
- Selector motor
- Simple, Advanced and Expert mode
- SL1 file (.sl1)
- Spool holder
- SuperPINDA
- Tank
- Thermistor
- Tilt
- Tilt motor
- Tooltips
- Touchscreen Display / Touch screen
- Tower / Z-Axis (SL1)
- Tube fitting
- USB flash drive
- USB port
- USB port (SL1)
- UV LEDs
- Variable layer height
- Wipe-tower (Purge-tower)
- xBuddy board
You can decrease (or increase) the print speed in two ways.
The easiest way to do it is by rotating the knob next to the LCD screen during the printing process. Counterclockwise = slow down, Clockwise = speed up. The percentage shown on your LCD is relative to the speeds set in PrusaSlicer.
You can also change the print speed in PrusaSlicer before slicing your model. First of all, you can choose the Quality print settings profile, and besides that, you can decrease the speeds in Print Settings -> Speed tab. Note that you have to be at least in Advanced mode to see the Speed option in the left main menu.
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.