English
1. Tools necessary for this chapter
Step 1 of 62 (Chapter 3 of 7)
Contents
Comments
⬢For this chapter, please prepare:
⬢T10 Torx key (screwdriver)
⬢2.5mm Allen key
Contents
Original Prusa XL Enclosure (1.0)
- 1. Introduction
- 2. Enclosure assembly
- 3. Printer upgrade
- Tools necessary for this chapter
- XL base covers removing
- XL Base nuts: parts preparation
- How to insert the nuts
- XL base nuts inserting
- Lower bellows holder: parts preparation
- Few tips before we start
- Right bellows magnet spacer
- Left bellows magnet spacer
- Lower magnets
- Lower bellows holder securing: left side
- Lower bellows holder securing: right side
- CoreXY inserts: parts preparation
- CoreXY inserts
- Upper magnet cover: parts preparation
- Few tips before we start
- Upper magnet cover assembly
- Upper magnets attaching
- Upper magnet cover securing: right side
- Upper magnet cover securing: left side
- Connection box: parts preparation
- Connection box assembly
- Fixing brackets: parts preparation
- Fixing bracket front left attaching
- Fixing bracket front left securing
- Fixing bracket front right securing
- Fixing bracket rear left securing
- Connection box securing
- Fixing bracket rear right securing
- Removing the rear Wi-Fi antenna
- XL buddy box
- Side antenna: cover removing
- Rear antenna: connector removing
- Nextruder unplugging
- Back cover removing
- Back cables releasing
- Fan & PE cable: parts preparation
- PE cable securing
- PE cable connecting
- Fan cable connecting
- Installing LED cable
- Installing LED cable
- Enclosure cables securing
- Securing the cables
- Back cover: parts preparation
- Back cover attaching
- Antenna cover attaching
- Antenna & Nextruder connecting
- XL buddy box covering
- CAUTION: Lubricant Handling
- Lower belt release
- Upper belt release
- Belt clamp: parts preparation
- Lower belt clamp replacing
- Lower belt securing
- Upper belt clamp replacing
- Upper belt securing
- Belt tightening
- Belt tensioning: video
- Bellows: parts preparation:
- Bellows installation
- Good job
- 4. Nextruder upgrade (Multi-Tool)
- 5. Nextruder upgrade (Single-Tool)
- 6. Enclosure secure
- Manual changelog XL Enclosure kit
Comments
Log in to post a comment
dsh1582
•
You guys need an updated set of instructions that is optimized for putting printer together with the enclosure from scratch. The amount of rework needed here is ridiculous.