• Čeština
  • Italiano
  • Deutsch
  • Polski
  • Français

Power Panic #17321 (XL)

Relevant for:
Last updated 5 months ago
This article is also available in following languages: 

What happened?

The Original Prusa XL is equipped with a Power Panic cable, which can recover the printer from a complete loss of power without needing batteries or an UPS. If the power panic cable is damaged or disconnected, the printer will not work, and show the text 'Power panic detected on startup. Check power panic cable'.

Error name: Power Panic

Error code: #17321

How to fix it? 

Make sure that you have a USB drive with the latest firmware connected to the printer. Go to the printer menu in Settings -> System -> Factory reset -> Hard Reset. The USB drive with the latest firmware has to be connected to the printer for the procedure. 

After that, it will be necessary to go through the initial printer calibration again.

In case that does not solve the issue, contact our Customer support.
Was this article helpful?


Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us