Each of the three stepper motors on the MMU unit is controlled by a TMC driver on the control board. In case there is an unexpected communication issue between the main microcontroller and the Idler motor TMC driver on the board, the error is shown.
Make sure you are using the MMU3 with the PD-board addon attached.
Verify all the cables are in good condition and the connections are stable.
Si vous avez une question sur un sujet qui n'est pas traité ici, consultez nos ressources supplémentaires.
Et si cela ne suffit pas, vous pouvez envoyer une demande à [email protected] ou via le bouton ci-dessous.